Airforce Gunpower High Flow Valve Assembly Short V2

Hi-Flow Valve with Assembly comprise of our custom PCP Tunes Valve, helps increase the output and provide consistent shots.

These are now available in shorter version as well.

These valve assemblies have been designed and tested to work at pressures up to 250 BAR (3625 PSI).

Comes with gauge on the valve assembly and the fill nipple for your quick fill requirements.

(These valve would only work with the newer frames with spin loc feature)

Burst disk has been installed to ensure safety factor while working at higher air pressures.

We highly recommend “Hi-Flow Valve with Assembly" installed on the "Buddy Bottle - BARE - 500cc 250BAR M18 x 1.5 Thread" for best results.

Do not sweat if you have an older frame without the Spin-Loc collars. We have the parts you need for the upgrade. 
You could buy the "Spin-Loc Conversion Kit" from us. Post upgrading your older frames with the conversion kit you could use these.

The valve assemblies do juice out 50% more energy that the max factory setups. (Along with the heavier hammer) 

MODEL CHECK: FOR THE MODELS BEFORE 2019 ONLY. (OLDER AND NEWER FRAMES)

Contact us if you need any customization and we shall be happy to get it done for you.

If you have any further query about the listed product you can use the above link to “Ask a Question”