Airforce Gunpower Texan 457 Power Upgrade Kit without Gauge and Fill Nipple

Our “Airforce Texan 457 Power Upgrade Kit Without Gauge and Fill Nipple” comprises of the high-power valve assembly which can operate at 250 bar fills without a valve lock. 

This Valve assembly works in conjunction with our “Airforce Texan Regulator with Dual Gauge V2”

This was designed so you could position the gauges and fill nipple for the above reg as per your convenience on the spin loc frames of your Texan. 

As the filling is from the fill nipple on the regulator, you would not require a factory fill nipple with ships with the factory valves nor the gauges as the regulator shows you both the regulated and the tank pressure.

Only buy this if you already have our “Airforce Texan Regulator with Dual Gauge V2”

If you are looking for a power upgrade without our regulators, then below is the product you need.
“Airforce Texan 457 Power Upgrade Kit”

You will never experience a low power shot when filled to the max 250 bar pressure, unlike what you must have seen in the factory valves when filled to the max pressure of 200 bar.

For the power valve to work, the hammer and hammer spring must be upgraded and is included along with the kit.

Features burst disk for safe fill pressures.

Innovative body which will prevent the valve from loosening as its designed to fit frames better. 
(For Spin-Loc models in Airforce and Gun Power frames only)

IMPORTANT NOTE: MAX WORKING PRESSURE OF THIS VALVE IS 250 BAR. (3625 PSI).

MAKE SURE YOUR TANK HAS AN EQUIVALENT OR HIGHER RATING BEFORE FILLING TO 250 BAR.

MODEL CHECK: THESE HAVE NOT BEEN TESTED AGAINST THE PERFORMANCE ON THE TX2 VALVES.

BE SURE TO READ THE DOC FOR INSTALLATION WHICH IS SENT ON EMAIL BEFORE YOU BEGIN THE UPGRADES.

Contact us if you need any customization and we shall be happy to get it done for you.

If you have any further query about the listed product you can use the above link to “Ask a Question”