-10%

Huma Artemis PP800 Tuning Regulator

Unfortunately the original valve assembly the Artemis (Spa / SMK) PP800 series pistol is not very consistent.

So, we made an additional tuning regulator for it and you will have a great consistent shot string.

This Huma-Air regulator is placed inside the pressure tube and stands on the valve house body.

You only need to remove the outside O Ring of the factory valve housing so the regulator can vent properly.

The combination of our vented regulator technic and the plenum for the regulated air volume makes will make your tuning process superior above all other regulators in the market.

No further modifications to your pressure tube must be done.

So, no drilling in the tube and no creeping up in power during time.

The PP800 offers a great platform for further tuning and modifications.

The benefits of the Artemis PP800 regulator made by Huma:
Higher accuracy of your air rifle due to the elimination of the pellet speed fluctuations.
A constant pellet speed over the full working pressure range.
Maximum use of the air volume due to our ultra-compact build.
It will give you a better shot count and a full flat shot string immediately.
Adding a regulator to your air rifle will probably give you the biggest benefit in the tuning process.
Often the rifle will make less noise due to better balance in air usage

Pressure settings of the Regulator:
The regulators come in the standard middle pressure range (MP: 70-150 bar output).
They come pre-set on the most common pressure setting, or we will adjust it according to your personal wishes.
It is also equipped with a clear pressure scale label, so you can easily re-adjust or fine tune the pressure setting suitable to your wishes.

When you order one of our regulators you will receive:
Your regulator pre-set on to your own wishes.
A pressure scale in Bar’s on the regulator, for fine-tuning or re-adjustment.
We will include a “Huma regulated” breech sticker.
Fitting instructions as pdf download.

Huma-Air Quality Control:
Huma regulators are CNC produced out of high-grade aircraft Aluminum and bronze.
To guarantee a perfect product, every regulator is manually assembled, tested and adjusted to the requested pressure.
We only use high-end materials and our Belleville springs are designed for critical applications to achieve the highest repeat accuracy.
This gives our regulators a repeat cycle less than 1% difference.

Fitting Instructions: Refer the correct model you have purchased from the below link.
https://www.huma-air.com/Fitting-instructions

If you have any further query about the listed product you can use the above link to “Ask a Question”