-10%

Huma BSA Scorpion 1200 SE External Tuning Regulator

For the scorpion .25 SE models and the Scorpion SE 1200 models we have model regulator available specially for the real power lovers.
This external regulator screws between pressure tube and gauge assembly.

The difference compared to the normal BSA "SE" regulator is that this regulator uses the original pressure gauge body what gives it a lot more regulated volume.
So it is specially made for the .25 scorpion 1200 SE rifle or .22 with extreme power levels.
After assembling the pressure gauge will indicate the regulated power.
It’s very easy to install on your rifle, just depressurize the rifle, unscrew the pressure tube and screw the regulator in its place and you are finished.

For the Scorpion 1200 SE in .177 and .22 you can also choose the BSA "SE" regulator.

The benefits of this regulator over other regulators currently on the market:
Higher accuracy of your rifle due to the elimination of the pellet speed fluctuations.
A constant pellet speed over the full working pressure range.
It will give you a better shot count and a full flat shot string immediately.
The regulator housing is made of extremely tough 42Cr steel.
Tested for a working pressure of at least 3x the working pressure of the rifle, for everyone’s safety.
DIY fitting is a real option for the most people.
High quality bluing, same colour as the original BSA pressure tube.
Adding a regulator to your air rifle will probably give you the biggest benefit in the tuning process.

When you order one of our regulators you will receive:
Your regulator pre-set on to your own wishes.
A pressure scale in Bar’s on the regulator, for fine-tuning or re-adjustment.
We will include a “Huma regulated” breech sticker.
Fitting instructions as pdf download.

Pressure settings of the Regulator:
The regulators come in the standard middle pressure range (MP: 70-150 bar output).
They come pre-set on the most common pressure setting, or we will adjust it according to your personal wishes.
It is also equipped with a clear pressure scale label, so you can very easy re-adjust or fine tune the pressure setting suitable to your wishes.

Huma-Air Quality Control:
Huma regulators are CNC produced out of high grade aircraft Aluminum and bronze.
To guarantee a perfect product, every regulator is manually assembled, tested and adjusted to the requested pressure.
We only use high-end materials and our Belleville springs are designed for critical applications to achieve the highest repeat accuracy.
This gives our regulators a repeat cycle less than 1% difference.

Fitting Instructions: Refer the correct model you have purchased from the below link.
https://www.huma-air.com/Fitting-instructions

If you have any further query about the listed product you can use the above link to “Ask a Question”